Sanyo SDNR - Change at Power on

DISPLAY PANEL MANUAL
4-11
4.7.2 Change at power ON
Set the Init mode SW to USER on INIT MODE SETTING of CONFIGURATION to change User Mode at the
timing of power ON. DISPLAY PANEL will start up on User Mode (screen No.1) from next power ON.
If screen No.1 is not registered, Screen No. Error will occur. When the DISPLAY PANEL is shipped, screen No.1
that can be arranged by V-SFT is set.
DISPLAY PANEL will start up on NR Mode (screen No.600) when the Init mode SW is set to NR.
Refer to Chapter 10 CONFIGURATION for detail of Init mode SW.