DISPLAY PANEL MANUAL
8-1
Chapter 8 MAINTENANCE mode
The operation and contents of the MAINTENANCE mode is described in this chapter. You are recommended
to read this chapter when you perform the maintenance of the NUTRUNNER.
8.1 About the MAINTENANCE mode.........................................................................................................8-2
8.2 T/T CHECK .........................................................................................................................................8-4
8.2.1 T/T CURRENT DATA ....................................................................................................................8-4
8.2.2 T/T CALIBRATION DATA ..............................................................................................................8-5
8.2.3 T/T OFFSET DATA .......................................................................................................................8-7
8.3 ANGLE DATA ......................................................................................................................................8-8
8.4 SYSTEM STATUS...............................................................................................................................8-9
8.5 I/O CHECK........................................................................................................................................8-10
8.5.1 DR INPUT CHECK ..................................................................................................................... 8-11
8.5.2 DR OUTPUT CHECK..................................................................................................................8-12
8.5.3 MC INPUT CHECK(Type M) .......................................................................................................8-13
8.5.4 MC OUTPUT CHECK(Type M) ...................................................................................................8-14
8.6 NG REPORT.....................................................................................................................................8-15
8.7 FASTENING REPORT(Type S).........................................................................................................8-18
8.8 FASTENING REPORT(Type M) ........................................................................................................8-19
8.9 MANUAL OPERATION......................................................................................................................8-21
To Next Page