5. FASTENING SETTING mode (Type S)
5-20
5.3.2 SELECT PROGRAM
● Setting of the SELECT PROGRAM
1) Select the SELECT PROGRAM from the PROGRAM SETTING menu. The following screen will be
displayed.
Figure 5.3-4 NR No. and PROGRAM No. input
2) Input the NUTRUNNER No. and PROGRAM No., then press EXEC. The following screen (SDN-DP06)
will be displayed. When SDN-DP12 is used, settings of 32 steps are displayed.
Figure 5.3-5 SELECT PROGRAM SETTING
3) Move the cursor to the desired item using “△▽” touch key. Then change the settings using DELETE,
CHANGE, INSERT and DETAIL touch key.
Press EXEC to write new settings to the NUTRUNNER.
Press QUIT to cancel all new settings.
To Next Page
Loading...