Sanyo SDNR - Parameter Switch

DISPLAY PANEL MANUAL
5-41
5.4.4 PARAMETER SWITCH
The PARAMETER SWITCH mode is used to “mark“ certain fastening parameters as USED or UNUSED for
display and/or control purposes as defined below.
●PARAMETER SWITCH setting
1) Select the PARAMETER SWITCH from the PARAMETER SETTING menu. The following screen will be
displayed. Input the No. of the NUTRUNNER and the parameter to be set up. The PARAMETER
SWITCH screen will be displayed when EXEC key is pressed. Press QUIT to return to the PARAMETER
SETTING menu.
Figure 5.4-8 PARAMETER SWITCH setting NR No. input
2) Following screen will be displayed.
Figure 5.4-9 PARAMETER SWITCH setting (SDN-DP06)