Sanyo SDNR - Parameter Driver Copy

5. FASTENING SETTING mode (Type S)
5-44
5.4.5 PARAMETER DRIVER COPY
 The DRIVER COPY is the function that allows a fastening parameter to be copied between DRIVERS.
● PARAMETER DRIVER COPY
1) Select the DRIVER COPY from the PARAMETER SETTING menu. The following screen will be
displayed.
Figure 5.4-11 PARAMETER DRIVER COPY
2) Input the “From NR. No.“ to select DRIVER, the “To NR. No.“ for destination and the “ COPY
PARAMETER No.“.
Press EXEC to copy the selected parameter.
Press QUIT to abort copying and return to the PARAMETER SETTING menu.