Sanyo SDNR - Option Board Setting

6. FASTENING SETTING mode (Type M)
6-26
6.9 OPTION BOARD SETTING
 The setting of the option board for the MULTI CONTROLLER is set.
●OPTION BOARD SETTING
1) Select the OPTION BOARD SETTING from the FASTENING SETTING menu. The following screen
will be displayed.
Figure 6.9-1 OPTION BOARD SETTING menu
2) Select the desired option from the menu.
3) Press EXIT to return to the FASTENING SETTING menu.
NOTE
Refer to the SDN-OP OPTION BOARD MANUAL for more details.
CAUTION
When the option select and the data output mode are set, other settings are done on the option
board.