Sanyo SDNR - Ng Parameter

DISPLAY PANEL MANUAL
5-39
5.4.2 NG PARAMETER
●NG PARAMETER SETTING
1) Select NG PARAMETER from the PARAMETER SETTING menu. The following screen will be displayed.
Input the No. of the NUTRUNNER and the parameter to be set up. The NG PARAMETER screen will be
displayed when EXEC key is pressed. Press QUIT to return to the PARAMETER SETTING menu.
Figure 5.4-4 NG PARAMETER - NR. No., parameter No. input
2) Following screen will be displayed.
Figure 5.4-5 NG PARAMETER setting
3 ) Press NEXT or PREV to change the page.
Move the cursor to the desired item using “ ∧∨“ touch key. Then input the number using numeric input
keys.
Press EXEC to write new settings to NUTRUNNER.
Press QUIT to abort all edits and return to the PARAMETER SETTING menu.