10. CONFIGURATION
10-4
10.3 PASSWORD SETTING
●Password Setting
1) The following screen will be displayed when PASSWORD SETTING is chosen from the
CONFIGURATION menu.
Figure 10.3-1 PASSWORD SETTING
2) Press touch switch of the desired setting for password SW 1 to 3.
Input new password for password 1 to 3 after erasing old one by CLR key.
3) Press EXEC to write new settings to the NUTRUNNER.
Press QUIT to cancel all new settings and return to the CONFIGURATION menu.
a. Password 1 to 3 SW
Password switches are set.
Password SW CONTENTS
OFF Password is invalid.
ON Password is valid.
Table 10.3-1 Password SW
b. Password 1 to 3
4 digits of password is set.
To Next Page
Loading...