Sanyo SDNR - Page 154

7. DATA DISPLAY mode
7-10
 The following data can be displayed in the DATA DISPLAY mode.
No. CONTENTS No. CONTENTS
1 JUDGEMENT 26 MINIMUM VALUE OF SLOPE 1
2 UPPER NG bit 1 27 MAXIMUM VALUE OF SLOPE 1
3 UPPER NG bit 2 28 MINIMUM VALUE OF SLOPE 2
4 LOWER NG bit 1 29 MAXIMUM VALUE OF SLOPE 2
5 LOWER NG bit 2 30 FINAL SLOPE TORQUE
6 STEP No. 31 YIELD POINT ANGLE
7 CYCLE TIME 32 STRETCH ANGLE
8 OFFSET TORQUE 33 SLOPE BASE VALUE
9 CYCLE PEAK TORQUE CW 34 SLOPE BASE ANGLE
10 CYCLE PEAK TORQUE CCW 35 SLOPE BASE TORQUE
11 TIGHTENING PEAK TORQUE 36 MINIMUM VALUE OF SLOPE 3
12 NEGATIVE PEAK TORQUE 37 MAXIMUM VALUE OF SLOPE 3
13 CYCLE PEAK CURRENT 38 MID.POINT JUDGEMENT TORQUE
14 TIGHTENING PEAK CURRENT 39
MID.POINT JUDGEMENT TIGHTENING
ANGLE
15 FINAL TORQUE 40 RUN DOWN ANGLE
16 TIGHTENING TIME 41
RUN DOWN TORQUE MINIMUM
JUDGEMENT ANGLE
17 TIGHTENING ANGLE 42
RUN DOWN TORQUE MAXIMUM
JUDGEMENT ANGLE
18 FINAL CURRENT 43
19 SEATING TORQUE 44 TORQUE GAIN CORRECTION
20 SEATING TIME 45 TORQUE OFFSET CORRECTION
21 SEATING ANGLE 46 ANGLE GAIN CORRECTION
22 SNUG TORQUE 47 ANGLE OFFSET CORRECTION
23 SNUG TIME 48 PROGRAM No. PARAMETER No.
24 SNUG ANGLE
25 MONITOR ANGLE
Table 7.5-1 DISPLAY ITEM SELECTION