8. MAINTENANCE mode
8-24
●MC COUNT RESET
1) The following screen will be displayed when the MC COUNT RESET is selected from the MANUAL
OPERATION mode menu.
Figure 8.9-4 MC COUNT RESET
2) Press EXEC to reset the count of the Multi-Controller.
Press QUIT to return the MANUAL OPERATION menu.
NO T E
The present count value is is displayed on the bottom of the display. The number of counts can be
from 0001 up to 9999. The number of counts will be displayed as 0000 when the count exceeds
9999.
If more than 10000 count is memorized, ‘----’ is displayed. It may occur when you use the
Multi-Controller at first from unpacking and so on. Reset the count of the Multi-Controller at this
mode or by using the I/O of the Multi-Controller.
To Next Page