Sanyo SDNR - Page 185

DISPLAY PANEL MANUAL
9-5
<Actual Time>
Sampling time of the torque curve is designated by the “Trq.Crv.Samp.Int” “Trq.Crv.Dt.size” control
parameter of maximum cycle time NR.
All NR are displayed by actual time.
If settings of their “Trq.Crv.Samp.Int” “Trq.Crv.Dt.size” are different, their torque curve are not displayed.
Same settings shall be inputted.
Horizontal axis (Angle) : Display method is different if display mode select is the Simple Mode or the Actual
Time.
<Simple Mode>
Angle range of horizontal axis is adjusted by the tightening angle of Display NR No.1.
All NR are displayed by actual angle.
Same settings shall be inputted.
If No.2 to 4 angle data is larger than No.1 angle data, No.2 to 4 angle data might not display in the
screen.
<Actual Time>
Angle range of horizontal axis is adjusted by NR No. of maximum angle data.
All NR are displayed by actual angle.
If settings of their “Trq.Crv.Samp.Int” “Trq.Crv.Dt.size” are different, their torque curve are not displayed.
Same settings shall be inputted.