DISPLAY PANEL MANUAL
5-3
The following four types of setting and the fastening setting backup can be performed in the FASTENING
SETTING mode.
Table 5.1-1 FASTENING SETTING mode menu and its contents
SETTING MODE MENU
CONTENTS
SYSTEM SETTING The system of the NUTRUNNER is set up.
PROGRAM SETTING
The program of the fastening operation is set up.
A maximum of eight programs can be set up.
PARAMETER SETTING
The fastening parameters such as the control parameters, the NG
parameters and the TROUBLE parameters are set up.
A maximum of 32 sets of parameters can be set up.
REVERSE SETTING A speed and acceleration of reverse operation is set up.
BACKUP The backup of the fastening setting is done.
To Next Page