5.2 WBM
On the device, you can limit the time available for access with Web Based Management. If no
entry is made for a specific time, the WBM session is closed.
This section describes commands relevant for the configuration of this feature.
5.2.1 The "show" commands
This section describes commands with which you display various settings.
5.2.1.1 show web-session-timeout
Description
This command shows the timeout setting for the WBM.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show web-session-timeout
Result
The timeout setting for the WBM is displayed.
5.2.2 Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
Functions specific to SCALANCE
5.2 WBM
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
114 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
