Siemens SCALANCE W738-1 M12 Configuration Guides

Parameter Description Range of values / note
read The data can be read.
Keyword
● ReadView
● none
write The data can be read and written
Keyword
● WriteView
● none
notify Changes can be sent as a tag.
Keyword
● NotifyView
● none
Storage Type Specifies whether the settings remain
following a restart.
● volatile :
The settings are lost after a
restart
● nonvolatile :
The settings are retained after
a restart
The keywords need to be specified.
If optional parameters are not specified when configuring a group, the default value will be
used.
Result
The settings for access to an SNMP group are configured.
Further notes
You delete the access to an SNMP group with the no snmp access command.
You display the configured SNMP groups with the show snmp group command.
You display the access configurations for SNMP groups with the show snmp group
access command.
You display the configured SNMP tree views with the show snmp viewtree command.
8.6.2.5 no snmp access
Description
With this command, you delete the access to an SNMP group.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Network protocols
8.6 SNMP
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
416 Configuration Manual, 09/2017, C79000-G8976-C324-08

Siemens SCALANCE W738-1 M12 Specifications

General

Brand	Siemens
Model	SCALANCE W738-1 M12
Category	Wireless Access Point
Language	English