7.1.1.8 show wlan client (Client)
Description
This command shows the client configuration of the SCALANCE W700 device, for example
how the MAC address is assigned to the client.
Note
This command is only available in the client mode.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show wlan client <wlan 0/X>
The parameter has the following meaning:
Parameter Description Range of values / note
wlan 0/X WLAN interface Enter a valid interface.
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 29)".
Result
The following client settings are displayed:
● MAC Mode
● Manual MAC Address
● Any SSID
● Roaming Threshold
● Background scan mode
● Background Scan Interval
● Scan Channels
Network structures
7.1 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 191
To Next Page
Loading...
Need help?
General
