show pnio
Result
The current PROFINET configuration is displayed.
4.1.1.12 show lldp neighbors
Description
This command shows the current content of the neighborhood table.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameter assignment:
show lldp neighbors
Result
The neighborhood table is displayed.
4.1.1.13 show lldp status
Description
This command shows per port whether LLDP frames are sent or received.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show lldp status [port {<interface-type> <interface-id>}]
Configuration
4.1 System
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 57
To Next Page
Loading...
Need help?
General
