Further notes
You display the setting with the show wlan client <wlan 0/X> command.
7.1.5.26 wlan client mac address (client)
Description
With this command, you specify the MAC address of the client.
Note
This command is only available in the client mode.
Requirement
● The MAC address is assigned to the client manually.
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call up the command with the following parameters:
wlan client mac address <mac-address>
The parameter has the following meaning:
Parameters Description Range of values / note
mac-address MAC address of the client aa:aa:aa:aa:aa:aa
Result
The MAC address was assigned to the client.
Further notes
You display the setting with the show wlan client <wlan 0/X> command.
Network structures
7.1 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 231
To Next Page
Loading...
Need help?
General
