Further notes
You display the setting with the show wlan security ap-radius-authenticator
command.
See also
show wlan security ap-radius-authenticator (Access Point) (Page 496)
11.3.2.5 wlan security ap-radius-authenticator port-number
Description
With this command, you configure the input port of the RADIUS server.
Note
This command is available only in access point mode.
Requirement
You are in the WLAN Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-wlan)#
Syntax
Call up the command with the following parameters:
wlan security ap-radius-authenticator port-number <index (1-2)>
<1-65535>
The parameters have the following meaning:
Parameters Description Range of values / note
index Index of the RADIUS server 1...2
1-65535 Number of port 1...6553
Result
The input port is configured.
Further notes
You display the setting with the show wlan security ap-radius-authenticator
command.
Security and authentication
11.3 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 503
To Next Page
Loading...
Need help?
General
