[<administrative distance>] [unicast]
})
Parameter Description Range of values / note
prefix len Number of bits belonging to the prefix
(from left to right)
1 ... 128 bits
NextHop IPv6 address of the gateway to which the IPv6 packets will be forwar‐
ded.
Enter a valid IPv6 address.
vlan Keyword for a VLAN connection -
vlan-id Number of the addressed VLAN 1 ... 4094
administrativ
e distance
Value for the administrative distance 1 ... 254
Default: 1
unicast Addressing mode unicast -
interface-
type
Type or speed of the interface Enter a valid interface.
interface-id Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Interface identifiers
and addresses (Page 29)".
Result
The entry is configured.
Further notes
You delete a static entry from the IPv6 routing table with the no ipv6 route command.
You display the IPv6 routing table with the show ipv6 route command.
8.2.3.8 no ipv6 default route
Description
With this command, you delete the IPv6 default route.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no ipv6 default route <prefix len>
Network protocols
8.2 IPv6 protocol
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
368 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
