Result
The sending of A-MSDU data packets is enabled.
Further notes
You display the setting with the show wlan advanced-11n <wlan 0/X> command.
You disable the function with the no wlan amsdu command.
7.1.5.10 no wlan amsdu
Description
With this command, you disable the sending of A-MSDU data packets. If the function is
disabled, only A-MSDU data packets can be received.
Requirement
● The IEEE 802.11n transmission standard is enabled.
● You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call the command without parameter assignment:
no wlan amsdu
Result
The sending of A-MSDU data packets is disabled.
Further notes
You display the setting with the show wlan advanced-11n <wlan 0/X> command.
You enable the function with the wlan ampsu command (default setting).
7.1.5.11 wlan amsdu packet-size
Description
With this command, you specify the maximum size of the A-MSDU data packet.
Network structures
7.1 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
218 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
