Result
The sending of AMPDU data packets is enabled.
Further notes
You display the setting with the show wlan advanced-11n <wlan 0/X> command.
You disable the function with the no wlan ampdu command.
See also
no wlan ampdu (Page 215)
7.1.5.6 no wlan ampdu
Description
With this command, you disable the sending of AMPDU data packets. If the function is disabled,
only AMPDU data packets can be received.
Requirement
● The IEEE 802.11n transmission standard is enabled.
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call the command without parameter assignment:
no wlan ampdu
Result
The sending of AMPDU data packets is disabled.
Further notes
You display the setting with the show wlan advanced-11n <wlan 0/X> command.
You enable the function with the wlan ampdu command (default setting).
See also
wlan ampdu (Page 214)
Network structures
7.1 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 215
To Next Page
Loading...
Need help?
General
