Parameter Description Range of values / note
interface-type Type of interface Specify a valid interface.
interface-id Module no. and port no. of the interface
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 29)".
Result
The ID of the addressed IPv4 address band is configured.
You are now in the DHCPPOOL Configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Further notes
You exit the DHCPPOOL configuration mode with the exit command.
You delete the entry with the no ip dhcp-server pool command.
8.5.2.5 no ip dhcp-server pool
Description
With this command, you delete the required IPv4 address band.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no ip dhcp-server pool <pool-id (1-1)>
The parameter has the following meaning:
Parameter Description Range of values / note
pool-id ID of the addressed IPv4 address band 1
Result
The required IPv4 address band is deleted.
Network protocols
8.5 DHCP server
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 393
To Next Page
Loading...
Need help?
General
