Syntax
Call up the command with the following parameters:
wlan alternative channel { show-channels | <number (0=auto)> }
The parameters have the following meaning:
Parameters Description Range of values / note
show-channels Lists all available channels. --
number Number of the alternative channel
If you want the access point to search
for a free channel itself, use "0".
Default value: 0 (AUTO)
Result
The alternative channel is set.
Further notes
You display the setting with the show wlan basic <wlan 0/X> command.
You enable the DFS function with the wlan dfs command.
See also
wlan dfs (Page 240)
7.1.5.5 wlan ampdu
Description
With this command, you enable the sending of AMPDU data packets. The function is enabled
as default.
Requirement
● The IEEE 802.11n transmission standard is enabled.
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call the command without parameter assignment:
wlan ampdu
Network structures
7.1 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
214 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
