7.1.7.2 wds partner mac (access point)
Description
With this command, you enter the MAC address of the WDS partner.
Note
This command is available only in access point mode.
Requirement
You are in the Interface Configuration mode for the WDS interface.
The command prompt is as follows:
cli (config-if-wdsX-0-Y)#
Syntax
Call up the command with the following parameters:
wds partner mac <mac-address>
The parameter has the following meaning:
Parameters Description
mac-address MAC address of the communications partner
Result
The MAC address is specified.
Further notes
You display the setting with the show wlan wds <wdsX 0/Y> command.
See also
wds partner id-type (access point) (Page 270)
Network structures
7.1 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 271
To Next Page
Loading...
Need help?
General
