8.5.3.11 no static-lease
Description
With this command, you delete the assignment of an IPv4 address to a MAC address.
Requirement
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Syntax
Call up the command with the following parameters:
no static-lease { mac <mac-address> | client-id <string> }
The parameter has the following meaning:
Parameter Description Range of values / note
mac Keyword for a MAC
address
-
mac-address Unicast MAC address Specify the MAC address.
aa:bb:cc:dd:ee:ff
client-id Keyword for a DHCP
client ID
-
string Freely definable
DHCP client ID
Enter the required designation.
Result
The assignment is deleted.
Further notes
You configure the assignment with the static-lease command.
8.6 SNMP
This section describes commands of the Simple Network Management Protocol (SNMP).
Network protocols
8.6 SNMP
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 405
To Next Page
Loading...
Need help?
General
