Result
The setting for the maximum packet size is no longer used.
Further notes
You display the configuration with the show ipv6 pmtu command.
You configure the maximum packet size with the ipv6 path mtu command.
8.2.3.5 ipv6 path mtu discover
Description
With this command, you enable the PMTU Discovery function. The function automatically
determines the optimum packet size along the path.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
ipv6 path mtu discover
Result
The PMTU Discovery function is enabled.
Further notes
You disable the PMTU Discovery function with the command no ipv6 path mtu
discover.
You display the settings with the show ipv6 pmtu command.
8.2.3.6 no ipv6 path mtu discover
Description
With this command, you disable the PMTU Discovery function.
Network protocols
8.2 IPv6 protocol
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
366 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
