Result
The role is created.
Note
Role name cannot be changed
After creating a role, the name of the role can no longer be changed.
If a name of a role needs to be changed, the role must be deleted and a new role created.
Note
Function rights changeable with restrictions
You can only change the function rights of a role when the role is no longer linked to a user.
Further notes
You delete a role with the no role command.
You show the created roles with the show roles command.
11.1.4.2 no role
Description
With this command, you delete a role.
Note
You can only delete a role when the role is not linked to a user.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no role <role-name>
The parameter has the following meaning:
Parameter Description Range of values / note
role-name Role name Enter the name of a role.
Security and authentication
11.1 User rights management
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
478 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
