5.4 iPCF
This section describes the commands relevant for working with the iPCF function (industrial
Point Coordination Function).
Note
This commands are only available with the following KEY-PLUGs:
● W780 iFeatures (MLFB 6GK5 907-8PA00)
● W740 iFeatures (MLFB 6GK5 907-4PA00)
5.4.1 The "show" commands
This section describes commands with which you display various settings.
5.4.1.1 show wlan ipcf
Note
This commands are only available with the following KEY-PLUGs:
● W780 iFeatures (MLFB 6GK5 907-8PA00)
● W740 iFeatures (MLFB 6GK5 907-4PA00)
Note
This command is only available with the following KEY-PLUG:
● W740 iFeatures (MLFB 6GK5 907-4PA00)
Description
This command shows the settings of iPCF.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
Functions specific to SCALANCE
5.4 iPCF
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 123
To Next Page
Loading...
Need help?
General
