Siemens SCALANCE W738-1 M12 Configuration Guides

8.6.2.10 snmp filterprofile
Description
With this command, you configure a filter that describes the access rights to the MIB tree.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
snmp filterprofile <profile-name> <OIDTree> [mask<OIDMask>]
{included|excluded}[{volatile|nonvolatile}]
The parameters have the following meaning:
Parameter Description Range of values / note
profile-
name
Name of the filter profile max. 32 characters
OIDTree Object ID Path information of the MIB tree
mask Keyword for the OID mask -
OIDMask Mask that filters access to the elements of
the MIB tree
A series of "0" and "1" separated by dots
in keeping with the path information of
the MIB tree
- Specifies whether the filtered elements are
used or excluded
● included
● excluded
- specifies whether the settings remain follow‐
ing a restart:
● volatile (volatile):
The default settings are used after a
restart
● nonvolatile (non-volatile):
The saved settings are used after a
restart
Note that the meaning of the filter mask changes depending on the "included/excluded"
parameter:
● ...0... and "included" means: Access denied
● ...0... and "excluded" means: Access permitted
● ...1... and "included" means: Access permitted
● ...1... and "excluded" means: Access denied
Network protocols
8.6 SNMP
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 421

Siemens SCALANCE W738-1 M12 Specifications

General

Brand	Siemens
Model	SCALANCE W738-1 M12
Category	Wireless Access Point
Language	English