7.1.1.10 show wlan client-list-vap (access point)
Description
This command shows the VAP interface via which the clients are logged on to the access point
in the form of a table.
Note
The command is available only in access point mode.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show wlan client-list-vap vapX 0/Y [AID]
The parameter has the following meaning:
Parameter Description Range of values / note
vapX 0/Y VAP interface Enter a valid interface.
AID Connection ID of the cli‐
ent.
-
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 29)".
Result
The table with the logged-on clients is displayed.
7.1.1.11 show wlan data rates (access point)
Description
This command shows the tables with the available data transmission speeds.
Note
This command is available only in access point mode.
Network structures
7.1 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 193
To Next Page
Loading...
Need help?
General
