At system start or when using the restart command with the option memoryor factory,
the following defaults apply:
Parameter Default value
size 32
count 3
timeout 1
Result
The messages relating to the response of the called node are displayed.
4.1.9 ping ipv6
Description
With this command, you request a response from a device in the network. This allows you to
check whether or not another node is reachable.
Requirement
● IPv6 is enabled.
● You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
ping
ipv6
{
<prefix%interface>
|
fqdn-name
<FQDN>
}
[repeat <count>]
[size <value>] [anycast] [source {vlan <id> | <source_prefix>}]
[timeout <value (1-100)>]
The parameters have the following meaning:
Parameter Description Range of values / note
prefix IPv6 address of the destination Enter a valid IPv6 address.
%interface optional parameter
Only necessary when the IPv6 ad‐
dress of the destination is a link-local
address.
Specify the interface via which the
packet will be sent.
fqdn-name Keyword for a domain name -
FQDN Domain name (Fully Qualified Do‐
main Name) of the called node
Maximum of 100 characters
repeat Keyword for the number of packets to
be requested
-
Configuration
4.1 System
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
64 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
