7.1.5.7 wlan ampdu bytes-limit
Description
With this command, you specify the maximum size of the AMPDU data packet in bytes.
Note
This command is available only in access point mode.
Requirement
● The IEEE 802.11n transmission standard is enabled.
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call up the command with the following parameters:
wlan ampdu bytes-limit <bytes(1024-65535)>
The parameter has the following meaning:
Parameters Description Range of values / note
bytes Size of the AMPDU data packet in bytes 1024 to 65535 bytes
Default: 50000 bytes
Result
The size for the AMPDU data packets is specified.
Further notes
You display the setting with the show wlan advanced-11n <wlan 0/X> command.
7.1.5.8 wlan ampdu frames-limit
Description
With this command, you specify the number of individual data packets (frames) grouped
together in one AMPDU data packet.
Network structures
7.1 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
216 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
