11.6.2 Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
11.6.2.1 authorized-manager ip-source
Description
With this command, you configure the interfaces and protocols via which an authorized
manager is allowed to access the device.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
authorized-manager ip-source <ip-address>
[{<subnet-mask>|/<prefix-length(0-32)>}]
[interface[<interface-type<0/a-b,0/c,...>]
[<interface-type<0/a-b,0/c,...>]]
[vlan<a,b
or
a-b
or
a,b,c-d>]
[service[snmp][telnet][http][https]
[ssh]]
The parameters have the following meaning:
Parameter Description Range of values / note
ip-address Specifies the network or the IP address for which
the IP manager is authorized
Enter a valid IPv4 address or a
network
subnet-mask Subnet mask that restricts the authorization Enter a valid mask
prefix-
length
Decimal representation of the mask as a number
of "1" bits
0 .. 32
interface Keyword for a an interface description -
interface-
type
Type or speed of the interface Enter a valid interface.
0/a-b,0/
c,...
Module no. and port no. of the interface
vlan Keyword for a VLAN connection -
Security and authentication
11.6 Management Access Control List
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
578 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
