7.1.5.43 wlan dtim (access point)
Description
With this command, you configure the DTIM interval. The DTIM interval (1-15) specifies the
number of beacons to be sent before the access point sends the packets (broadcast/unicast/
multicast) to the client.
If, for example, you enter "5", this would mean that the access point collects the packets and
sends them after every fifth beacon.
Note
This command is available only in access point mode.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call up the command with the following parameters:
wlan dtim <1-15>
The parameter has the following meaning:
Parameters Description Range of values / note
1-15 DTIM interval after which the collected pack‐
ets are sent to the client.
1...15
Default: 1
Result
The DTIM interval is configured.
Further notes
You display the setting with the show wlan advanced <wlan 0/X> command.
Network structures
7.1 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
246 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
