11.3.5.19 no vap inter-ap-blocking block gratuitous arp
Description
This command allows the forwarding of gratuitous ARP packets.
Note
The command is only available when the following requirements are met:
● Access point mode
● The SCALANCE W700 device is equipped with one of the following KEY-PLUGs:
– W780 iFeatures (MLFB 6GK5907-8PA00)
– W700 Security (MLFB 6GK5907-0PA00)
Requirement
You are in the Interface Configuration mode of the VAP interface.
The command prompt is as follows:
cli (config-if-vapX-0-Y)#
Syntax
Call the command without parameters:
no vap inter-ap-blocking block gratuitous arp
Result
Gratuitous ARP packets are also forwarded.
11.3.5.20 vap inter-ap-blocking block non-ip-traffic
Description
This command restricts the communication between the client and the SCALANCE W700
devices configured as permitted communications partners on the access points to IP packets.
Note
The command is only available when the following requirements are met:
● Access point mode
● The SCALANCE W700 device is equipped with one of the following KEY-PLUGs:
– W780 iFeatures (MLFB 6GK5907-8PA00)
– W700 Security (MLFB 6GK5907-0PA00)
Security and authentication
11.3 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 543
To Next Page
Loading...
Need help?
General
