Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-wlan-context-x)#
Syntax
Call the command without parameter assignment:
wlan security dot1x check-server-certificate
Result
Validation is enabled.
Further notes
You display the settings with the show wlan security command.
You disable the validity check with the no wlan security dot1x check-server-
certificate command (default setting).
See also
no wlan security dot1x check-server-certificate (client) (Page 518)
11.3.4.5 no wlan security dot1x check-server-certificate (client)
Description
With this command, you disable the validation of the server certificate on the client. This setting
is activated as default.
Note
This command is only available in the client mode.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-wlan-context-x)#
Security and authentication
11.3 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
518 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
