wlan dfs prefer-configured-channel
Result
The function is enabled.
Further notes
You display the setting with the show wlan advanced <wlan 0/X> command.
You disable the function with the no wlan dfs prefer-configured-channel command
(default setting).
7.1.5.38 no wlan dfs prefer-configured-channel
Description
With this command you disable the access point changing back to the configured channel
automatically after the channel is released again following a blockage.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call the command without parameter assignment:
no wlan dfs prefer-configured-channel
Result
The function is disabled.
Further notes
You display the setting with the show wlan advanced <wlan 0/X> command.
You enable the function with the wlan dfs prefer-configured-channel command.
Network structures
7.1 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
242 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
