Result
The specified DHCP option is deleted.
Further notes
You configure the DHCP options 12, 66 and 67 with the option value-string command.
You configure the DHCP options 3 and 6 with the option command.
8.5.3.7 pool-enable
Description
With this command you specify that this IPv4 address band will be used.
Requirement
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Syntax
Call the command without parameter assignment:
pool-enable
Result
The setting is enabled.
Note
If the IPv4 address band is enabled, the following parameters can no longer be edited:
● DHCP options (option ...)
● Port Range (ports)
● Relay Agent Information (relay-information)
● Static Leases (static-lease)
Further notes
You display the setting with the show ip dhcp-server pools command.
You disable the setting with the no pool-enable command.
Network protocols
8.5 DHCP server
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 401
To Next Page
Loading...
