8.5.2.1 ip dhcp-server
Description
With this command, you enable the DHCP server on the device.
Note
To avoid conflicts with IPv4 addresses, only one device may be configured as a DHCP server
in the network.
Note
Maximum number of IP addresses
The maximum number of IPv4 addresses that the DHCP server supports is 100. In other words,
a total of 100 IPv4 addresses (dynamic + static).
With the static assignments, you can create a maximum of 20 entries.
Requirement
● NAT is enabled in Client mode
● You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
ip dhcp-server
Result
The DHCP server is enabled.
Further notes
You disable the DHCP server with the no ip dhcp-server. command.
8.5.2.2 no ip dhcp-server
Description
With this command, you disable the DHCP server on the device.
Network protocols
8.5 DHCP server
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
390 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
