You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
8.11.2.1 ssh-server
Description
With this command, you enable the SSH protocol on the device.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
ssh-server
As default the function is "enabled".
Result
The SSH protocol is enabled on the device.
Further notes
You disable the SSH protocol with the no ssh-server command.
8.11.2.2 no ssh-server
Description
With this command, you disable the SSH protocol on the device.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Network protocols
8.11 SSH server
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
448 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
