See also
wlan allowed channels only (Page 212)
7.1.5.2 wlan allowed channels only
Description
With this command, you enable the "Use allowed channels only" function. Only the
channels you specified with the wlan allowed channels list command are used.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call the command without parameter assignment:
wlan allowed channels only
Result
The function is enabled.
Further notes
You display the setting with the show wlan allowed channels <wlan 0/X>command.
You disable the function with the no wlan allowed channels only command.
See also
wlan allowed channels (Page 210)
no wlan allowed channels only (Page 212)
7.1.5.3 no wlan allowed channels only
Description
With this command, you disable the "Use allowed channels only" function. This is the
default setting.
Network structures
7.1 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
212 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
