Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show im
Result
The information is displayed.
4.1.1.6 show interfaces
Description
This command shows the status and the configuration of one, several or all interfaces.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show interfaces
[{
[<interface-type><interface-id>]
[{description|status}]
|
{vlan<vlan-id(1-4094)>}
}]
The parameters have the following meaning:
Parameter Description Range of values / note
interface-
type
Type or speed of the interface Enter a valid interface.
interface-id Module no. and port no. of the interface
description Shows the description of the interface -
status Shows the status of the interface -
Configuration
4.1 System
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
52 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
