Siemens SCALANCE W738-1 M12 Configuration Guides

Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
no ip dhcp-server
Result
The DHCP server is disabled.
Further notes
You enable the DHCP server with the ip dhcp-server command.
8.5.2.3 ip dhcp-server icmp-probe
Description
With this command you enable the function "Probe address with ICMP echo before offer". The
DHCP server checks whether or not the IPv4 address has already been assigned. If no reply
is received, the DHCP server can assign the IPv4 address.
Note
With static assignments, this check is not made.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
ip dhcp-server icmp-probe
Network protocols
8.5 DHCP server
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 391

Siemens SCALANCE W738-1 M12 Specifications

General

Brand	Siemens
Model	SCALANCE W738-1 M12
Category	Wireless Access Point
Language	English