Description
With this command, you enable the forwarding of multicast frames. The multicast frames
incoming on the WLAN interface are forwarded via the Ethernet interface into the internal
network.
Requirement
● You are now in the NAT Configuration mode.
The command prompt is as follows:
cli(config-nat)#
Syntax
Call the command without parameter assignment:
nat ipv4 multicast forward global-to-local
Result
The forwarding of multicast frames is enabled.
Further notes
You disable the forwarding with the no nat ipv4 multicast forward global-to-
local command.
10.1.3.9 no nat ipv4 multicast forward global-to-local (Client)
Note
This command is only available in the client mode.
Description
With this command, you disable the forwarding of multicast frames. The multicast frames
incoming on the WLAN interface are not forwarded.
Requirement
You are now in the NAT Configuration mode.
The command prompt is as follows:
cli(config-nat)#
Layer 3 functions
10.1 NAT
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 465
To Next Page
Loading...
Need help?
General
