The parameters have the following meaning:
Parameters Description
all All frames (with and without VLAN variables) are accepted
tagged Only frames with VLAN variables are accepted
At system start or when using the restart command with the option memoryor factory,
the following defaults apply:
● The function is configured for all.
Result
The setting is enabled.
Further notes
You can display the status of this function and other information with the show vlan port
config command.
7.2.3.2 switchport access vlan
Description
With this command, you assign an VLAN to an interface and configure the port VLAN identifier
(PVID) for it.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
switchport access vlan <vlan-id(1-4094)>
The parameter has the following meaning:
Parameter Description Range of values / note
vlan-id Number of the addressed VLAN 1 ... 4094
Result
The Interface is added to the VLAN as an untagged port and the corresponding VLAN ID is
set.
Network structures
7.2 VLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 291
To Next Page
Loading...
Need help?
General
