Siemens SCALANCE W738-1 M12 Configuration Guides

7.3.4.4 no spanning-tree auto-edge
Description
With this command, you disable automatic discovery of a bridge connected to the interface.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no spanning-tree auto-edge
Result
The automatic discovery of a bridge on the interface is disabled.
Further notes
The automatic discovery of a bridge on the interface is enabled with the spanning-tree
auto-edge command.
7.3.4.5 spanning-tree bdpufilter
Description
With this command, you configure the BPDU transmit status for a port.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
spanning-tree bpdufilter{disable|enable}
Network structures
7.3 Spanning Tree
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
328 Configuration Manual, 09/2017, C79000-G8976-C324-08

Siemens SCALANCE W738-1 M12 Specifications

General

Brand	Siemens
Model	SCALANCE W738-1 M12
Category	Wireless Access Point
Language	English