Requirement
● The name of the file is specified
● You are in the LOADSAVE configuration mode.
The command prompt is:
cli(config-loadsave)#
Syntax
Call up the command with the following parameters:
sftp save {showfiles|filetype<filetype>}
The parameters have the following meaning:
Parameter Description Range of values / note
showfiles Shows the available files -
filetype Keyword for a file type to be loaded -
filetype Name of the file type max. 100 characters
Result
The file types are displayed or the file is copied.
Further notes
You configure the name of the file with the sftp filename command.
With the "show loadsave files" command, you can display the file types.
4.2.5.9 sftp server
Description
With this command, you configure the access to an SFTP server.
Requirement
You are in the LOADSAVE configuration mode.
The command prompt is as follows:
cli(config-loadsave)#
Syntax
Call up the command with the following parameters:
sftp server {ipv4 <ucast-addr> | fqdn-name <FQDN> | ipv6 <ip6_addr>}
[port <tcp port (1-65535)>] [user <username>] [password <password>]
Configuration
4.2 Load and Save
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 95
To Next Page
Loading...
Need help?
General
