Further notes
You show the NAT configuration and the translation list with the show nat command.
See also
show nat (Client) (Page 456)
10.1.3.6 nat interface (Client)
Note
This command is only available in the client mode.
Description
With this command, you enable NAT for the Ethernet interface.
Requirement
● You are now in the NAT Configuration mode.
The command prompt is as follows:
cli(config-nat)#
Syntax
Call up the command with the following parameters:
nat interface <interface-type><interface-id>}
The parameters have the following meaning:
Parameter Description Range of values / note
interface-type Type or speed of the interface Enter a valid interface.
interface-id Module no. and port no. of the interface
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 29)".
Result
NAT is activated for the Ethernet interface.
Further notes
You disable NAT with the no nat interface command.
You configure the MAC mode with the wlan client mac mode command.
Layer 3 functions
10.1 NAT
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 463
To Next Page
Loading...
Need help?
General
