See also
no wlan security ap-radius-authenticator primary (Page 505)
show wlan security ap-radius-authenticator (Access Point) (Page 496)
11.3.2.7 no wlan security ap-radius-authenticator primary
Description
With this command, you disable the primary server.
Note
This command is available only in access point mode.
Requirement
You are in the WLAN Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-wlan)#
Syntax
Call up the command with the following parameters:
no wlan security ap-radius-authenticator primary <index (1-2)>
The parameter has the following meaning:
Parameters Description Range of values / note
index Index of the RADIUS server 1...2
Result
The primary server is disabled.
Further notes
You enable the setting with the wlan security ap-radius-authenticator primary
command.
You display the setting with the show wlan security ap-radius-authenticator
command.
Security and authentication
11.3 WLAN
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08 505
To Next Page
Loading...
Need help?
General
