Syntax
Call the command without parameter assignment:
show ipv6 pmtu
Result
The settings are displayed.
8.2.2.3 show ipv6 route
Description
This command shows the routes currently being used.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameter assignment:
show ipv6 route
Result
The IPv6 routing table is displayed.
Further notes
You configure a static entry with the ipv6 route command.
8.2.2.4 show ipv6 static route
Description
This command shows the routes that were generated statically.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
Network protocols
8.2 IPv6 protocol
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
360 Configuration Manual, 09/2017, C79000-G8976-C324-08
To Next Page
Loading...
Need help?
General
